Tuesday, January 25, 2011

Eldar Table pt. 1

Here is something I've been working on. This is just a test section for a much larger project. A Eldar themed modular board. This is a project between myself and a good friend, we've been planning this since September.





Here is the fun part... led illumination on the water. The water will play a big part of the board. Once we are producing the board sections I'll show the plans. So you all know what we are going for. Then the terrain, lots of fun planned for that as well.


Monday, January 24, 2011

Forgeworld Eldar Vampire Hunter pt.2

Small Update: The main Hull is glued and green stuff to fill in the gaps.







As I started to fill in the gaps I realized that some of the parts didn't line up right. I knew some of it would when I dry fit everything but... Green stuff to the rescue.






The edge from the head to the body was fine but I want it to look seamless, also added more from the wing section to the hull, feels more eldar.






Also did the same for the tail end of the wing, I didn't like how it just ends abruptly. It all looks a mess right now but when it's sanded it will look better... I hope.






Just more adding detail. The cockpit section was a greater width than the body so the is a 2 mm difference. I sculpted some extra plates to make it more seamless...

Friday, January 14, 2011

Forgeworld Eldar Vampire Hunter pt.1

As of right now this model is held together entirely by brass rod and tension. I used a 1 inch acrylic rod for the stem, which I've not seen anyone else try... It's a flyer! why not use something that is clear?